TruckVault Care and Maintenance

All TruckVault Products except Extreme Series All-Weather TruckVault

The rollers (above), located at the back of the drawers, and the casters (below), located inside the TruckVault and visible when the drawers are removed, should be lubricated every three months with silicone spray.
• Every three months remove drawers and use silicone lubrication spray on the plastic L-channels on both bottom corners and both the rollers and casters inside the TruckVault (see right). Silicone lubrication spray can be purchased at any hardware store.


• If carpet requires cleaning, use a carpet shampoo that is recommended by your vehicle's manufacturer.


• If your TruckVault has a mechanical lockdown method, a yearly check to make sure screws or bolts are tight is advised.


• If your TruckVault has adjustable tie down straps at the back, an annual check for connection and tension is advised.


• DO NOT lubricate TruckVault products with drawer slides, as they are pre-lubricated at the factory.


• Always make sure drawers are locked prior to driving your vehicle.

Extreme Series All-Weather TruckVault Products

The cam on the VectorLock may be adjusted using an Allen Wrench, which is included with your Extreme Series TruckVault. Doing so takes just seconds and prevents the development of leaks.
• Every three months, adjust the cam on your VectorLock to ensure proper compression on drawer seal. This is a very important step to prevent leaks from developing, as the drawer seal will compress over time.


• If desired, the outside coating can be sprayed and wiped down with Pledge furniture cleaner prior to installing to prevent the coating from dulling under weather conditions. This step may be repeated as desired after the TruckVault is thoroughly cleaned.


• If the coating becomes damaged to the point that it compromises the waterproofing of your TruckVault, it may be repaired by either an Arma or a Line-X authorized dealer.


• Every three months, remove the drawers and use silicone lubrication spray on the plastic L-channels on both bottom corners and rollers inside the vault. (See above)


• If your TruckVault uses the turnbuckle lockdown method, an annual check to ensure turnbuckles are hand tight and that the jam nut is fully tightened is advised.